Catalina - Capri - 25s International Assocaition Logo(2006)  
Assn Members Area · Join
h.jpg Home.
a.jpg Association Forum
s.jpg Ships Store
c.jpg Cruising
r.jpg Racing
t.jpg Technical Tips
g.jpg Photo Gallery - New
o.jpg Boat Search - Updated
m.jpg Manuals & Brochures
3rdrpt.jpg Swap Meet
l.jpg Links
f.jpg Officer Flag Line & Staff
b.jpg Bylaws & Constitution
 
1.jpg Members Area
1.jpg Join the Association
 
Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
 
Association Forum
Association Forum
Home | Profile | Register | Active Topics | Forum Users | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Catalina/Capri 25/250 Sailor's Forums
 Catalina 25 Specific Forum
 Inspection port size		  New Topic  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

stang9150
Navigator

Member Avatar

USA
138 Posts
Initially Posted - 04/22/2018 :  12:07:36  Show Profile
I need to replace the upper rudder hardware. They use to have the kit on Catalina direct with the inspection port. It appears that is gone I can not find it. Was it a 4 inch port?

islander
Master Marine Consultant

Members Avatar

USA
3992 Posts
Response Posted - 04/22/2018 :  17:37:03  Show Profile
I used a 4" port. They can be had at any marine store or off the internet. Just remember to measure down the transom to the gudgeon then transfer the measurement to the interior.https://www.westmarine.com/buy/west-marine--4-screw-in-deck-plate--11743002?recordNum=1
Scott-"IMPULSE"87'C25/SR/WK/Din.#5688
Sailing out of Glen Cove,L.I Sound


Edited by - islander on 04/22/2018 18:00:10
Go to Top of Page

JB
Navigator

Members Avatar

USA
110 Posts
Response Posted - 04/23/2018 :  08:54:05  Show Profile
The hole saw that came with the kit had a short centering drill bit. There isn't much gap between the between inner and outer hull and a normal bit is too long.
1988 C25 Wing Keel Std Rig Tohatsu 9.9 Tiller Steering and 2003 C250 Wing Keel Std Rig Inboard Diesel Wheel Steering
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Topic Locked
 Printer Friendly
Jump To:
Association Forum © since 1999 Catalina Capri 25s International Association Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.06
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.