Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
PB1
Posted - 06/21/2025 : 11:18:30 Just looking for common areas to inspect for this year. It's a WB, with pedestal.
Overall it looks very good, but she's still 27 years old!
7 L A T E S T R E P L I E S (Newest First)
Russ.Johnson
Posted - 06/22/2025 : 20:18:27 Hi PB, I have a new question. There are several version of wheel steering. Look at the wire connection to the rudder control arm. Version-A has 1-wire (called push/pull) Version-B has 2-wires (called pull/pull) Both versions are factory delivered from Edson Marine.
On this forum only, there is another version called free-cable system. This was a member invented upgrade. Your boat was most likely a 2-wire Edson system, but the previous owner might have replaced it with the free-wire system.
Russ.Johnson
Posted - 06/22/2025 : 20:09:57 Hi PB,
I also have wheel steering and it is above the water line. There’s not much to fail. There is a rubber cover (kinda like a CV boot on a front-wheel drive car).
Now we have more information. If you are in a freeze zone, then check all water-related areas. If your boat has always been on the trailer during winter then the ballast tank should always been dry. The drinking water tank in the bow and all water lines to the galley and head could have frozen at some point. It’s very important to drain that tank. If the previous owner drained on the trailer and the trailer was not level then some water might remain. Any freezing can cause leaks.
Because of your other posts, please keep your porti-potty and not replace it with a marine head.
PB1
Posted - 06/22/2025 : 18:39:36 Thanks! It's a freshwater boat in Ontario Canada. Unlikely the standing rigging needs replaced due to short season and no salt. Unless the rigging is inherently failure prone for some reason?
With pedestal steering what holes through the transom should be inspected for water instrusion?
Russ.Johnson
Posted - 06/22/2025 : 11:30:32 Hi PB, Here’s a post about Mast Sheaves.
Standing rigging is always the concern because of the damage caused by failure. If you have a C250WB then hopefully it’s mast down on the trailer. Inspect in mast crane, stays, shrouds, turnbuckles, and chain plates. Any corrosion or worn fittings are worrisome.
Do you or the former owner sail in freshwater or saltwater?
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.