Catalina - Capri - 25s International Assocaition Logo(2006)  
Assn Members Area · Join
h.jpg Home.
a.jpg Association Forum
s.jpg Ships Store
c.jpg Cruising
r.jpg Racing
t.jpg Technical Tips
g.jpg Photo Gallery - New
o.jpg Boat Search - Updated
m.jpg Manuals & Brochures
3rdrpt.jpg Swap Meet
l.jpg Links
f.jpg Officer Flag Line & Staff
b.jpg Bylaws & Constitution
 
1.jpg Members Area
1.jpg Join the Association
 
Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
 
Association Forum
Association Forum
Home | Profile | Register | Active Topics | Forum Users | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Catalina/Capri 25/250 Sailor's Forums
 Catalina 250 Specific Forum
 Think this could work for doing the upgrade?		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

doublereefed
Navigator

Member Avatar

167 Posts
Initially Posted - 07/25/2021 :  17:44:49  Show Profile  Reply with Quote
Do you think this could work (see the YouTube link below) for replacing that turning block assembly? I would have to cut that pin out but I'm thinking I will use a jig saw. Drill a hole in the ball shaped turning ball, stick the drill in it so it won't spin, and then use a jig saw right down the middle.

After that is out would have to get into the boat to insert the new turning block assembly, probably in and out a few times to make sure i like the placement, then drill that retaining pin. I ordered the lifting pennant block as well, can inspect the existing and replace if necessary.

Then reeve the line.

My only alternative is to build two large racks, think very big sawhorses, and pay for a crane to lift on and off.

Thoughts from you seasoned C250 maintenance experts?

https://www.youtube.com/watch?v=sz6zcdeeuj4
'95 C250 WB #61
Midway, UT

doublereefed
Navigator

Members Avatar

167 Posts
Response Posted - 07/27/2021 :  09:09:44  Show Profile  Reply with Quote
(cue sound: wind whistling through the trees, the sound of crickets...) Sounds like I should probably build those beefy sawhorses...
'95 C250 WB #61
Midway, UT
Go to Top of Page

Steve Milby
Past Commodore

Members Avatar

USA
5851 Posts
Response Posted - 07/27/2021 :  10:08:08  Show Profile  Reply with Quote
I haven't owned a C250 and don't know what you need to do to replace the lifting gear, but a properly maintained sailboat can be careened. If you sail a boat with too much sail area in too much wind, it will heel over until the mast is at least parallel to the water. I did just that several times with my C25. If the rig is tuned properly, the mast is in column and the stays have their full strength, then it shouldn't hurt the boat to attach a line to the top of the mast and pull on it enough to careen the boat.
Steve Milby J/24 "Captiva Wind"
previously C&C 35, Cal 25, C25 TR/FK, C22
Past Commodore
Go to Top of Page

Robb
1st Mate

Members Avatar

Canada
31 Posts
Response Posted - 07/27/2021 :  22:52:04  Show Profile  Reply with Quote
I'll weigh in here. Being a safety guy, I was a little concerned that the helpers in the video were essentially under a boat that could tip back up if a rope released or a component on the mast/rigging failed. I also note that the boat in the video appears to be a 20 footer (not sure of the manufacturer) and its likely substantially lighter than your 250. Even in WB form, the 250 is a pretty heavy boat. If it were me, I'd go the crane/stand route, as a mishap could cause a lot of damage to your boat - or worse - you. You may be able to pull off the careen but do you want to risk it?
Robb
2004 C250 WK hull# 739
Go to Top of Page

Voyager
Master Marine Consultant

Members Avatar

USA
5231 Posts
Response Posted - 07/28/2021 :  04:40:05  Show Profile  Reply with Quote
I don’t have a swing keel but I’ll relate a quick story about my experience trying to tip my C25. I needed to change my anchor light and tighten up my wind vane. I didn’t want to drop the mast because, well, it’s a pain in the neck, frankly. In my harbor we have a floating dock with a big ramp that goes up to an upper deck. At dead low tide, the deck is about 7 feet below the top of the mast. I reasoned that if I could tip the boat by about 25° over, I could easily reach the mast top from the upper deck and do the repairs.
So I rigged the boat with fenders along the dock, asked two big guys to sit on the gunewale and started pulling on a looped line I ran up the mast using the halyard. I pulled as hard as I could and I had zero luck tipping the boat any more than about 5-8° according to my tip-o-meter. If I had three guys pulling on the mast, I still think it would be nearly impossible to get the boat to tip.
Now this is with a 1700 pound keel so it’s pretty heavy. If you beach your boat and the keel is retracted, that’s another set of variables. Nonetheless, the C25/250s are a MUCH heavier boat than a large dinghy…
Bruce Ross
Passage ~ SR-FK ~ C25 #5032

Port Captain — Milford, CT
Go to Top of Page

doublereefed
Navigator

Members Avatar

167 Posts
Response Posted - 07/28/2021 :  08:34:09  Show Profile  Reply with Quote
Yes, I think caution should rule the decision. I also would like to inspect the keel pivot, might even do some touch up bottom paint. So... sawhorses it is. Thanks for the feedback.
'95 C250 WB #61
Midway, UT
Go to Top of Page

Steve Milby
Past Commodore

Members Avatar

USA
5851 Posts
Response Posted - 07/28/2021 :  09:31:39  Show Profile  Reply with Quote
Do you have a trailer? I painted the bottom of a C22 by jacking up the complete boat and trailer. Then I built a wood cradle under it and lowered the whole rig. The boat rested on the cradle and the trailer was lowered to the ground.

Is your boat at a marina that has a travelift or other means of hoisting a boat out of the water? Many marinas with a travelift will hoist your boat out of the water and leave it hanging in the straps for an hour to let you make a quick repair. They call it a short hoist, and charge less for it than a normal haul out.
Steve Milby J/24 "Captiva Wind"
previously C&C 35, Cal 25, C25 TR/FK, C22
Past Commodore
Go to Top of Page

Steve Milby
Past Commodore

Members Avatar

USA
5851 Posts
Response Posted - 07/28/2021 :  10:36:07  Show Profile  Reply with Quote
I'm not recommending careening the boat. There's obviously risk that a mast stay or chainplate might fail, but if your boat has a weakness in the rigging that would break when careened, it could just as readily fail in a strong gust under sail. Nevertheless, this discussion reminded me of a video that illustrates the fact that you can hang a huge load from the top of a well maintained mast, and careen the boat. Check it out. https://www.youtube.com/watch?v=ufmT5TbRx1g
Steve Milby J/24 "Captiva Wind"
previously C&C 35, Cal 25, C25 TR/FK, C22
Past Commodore
Go to Top of Page

Robb
1st Mate

Members Avatar

Canada
31 Posts
Response Posted - 07/29/2021 :  00:01:54  Show Profile  Reply with Quote
Cool video, thanks! I didn't know that was possible. They made it look easy but I'm sure they have some practice.
Robb
2004 C250 WK hull# 739
Go to Top of Page

Steve Milby
Past Commodore

Members Avatar

USA
5851 Posts
Response Posted - 07/29/2021 :  04:21:18  Show Profile  Reply with Quote
quote:
Originally posted by Robb

Cool video, thanks! I didn't know that was possible. They made it look easy but I'm sure they have some practice.
You have to wonder what motivated them to do that. Maybe cheaper slip fees on the other side of the bridge?
Steve Milby J/24 "Captiva Wind"
previously C&C 35, Cal 25, C25 TR/FK, C22
Past Commodore
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Association Forum © since 1999 Catalina Capri 25s International Association Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.06
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.