Notice:
The advice given on this site is based upon individual or quoted experience, yours may differ.
The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.
I tried to drill as the drawing advised, but found there is a fiberglas covered wood stringer (balsa?) where the aft bulkhead is attached. after carefully going as far as I could I still could not observe any light coming from the hole or from the bilge. (NO, I didn't go through the hull! )
Any thoughts on this?
My boat was built in August 2004.
Jeff McK Formerly Event Horizon (sold) C250 WK #805
I could not figure this out either.........so I laid down in the aft area during a wicked rain storm last weekend for about an hour and found the leaks and fixed them. The rear speakers cables coming thru were not completely sealed. Now,looking back,that was what I should have done in the first place,look for the problem. paulj #719
Notice: The advice given on this site is based upon individual or quoted experience, yours may differ. The Officers, Staff and members of this site only provide information based upon the concept that anyone utilizing this information does so at their own risk and holds harmless all contributors to this site.